Hi Tom,
hopefully I will be ready in a couple of weeks with my lathe so I can start running some tests on threading. It's been a long time since I last did make som threads and I believe I have Index + 6-8 pulses that I did run tests for Art way back and it did work very well.
I will send a message when I am up and running. The whole rework with changing CPU and TFT and a lot of other mechanical modifications has take much longer than planned, also we have had a very very cold winter so working in the shop was not advised, now it is better after installing new heating system. So my milling machine is also at stand still at this time but soon I hope I get to get all electrics fixed.
Cheers Bengt
--- In DynoMotion@yahoogroups.com, Tom Kerekes <tk@...> wrote:
>
> Hi Ross,
>
> I think those issues are specific to the Parallel port driver. KFlop uses its
> own algorithms using floating point math and already handles the spindle
> speeding up as well as slowing down.
>
> Regards
> TKÂ
>
>
>
>
> ________________________________
> From: fermanz <ferman@...>
> To: DynoMotion@yahoogroups.com
> Sent: Sat, March 5, 2011 1:27:42 PM
> Subject: [DynoMotion] Threading in Mach3
>
> Â
> Hi Tom,
> There has been a lot of discussion over at the mach1mach2 forum about threading
> and Art has come up with a new driver for Mach3.
> Do you think it necessary for us to update to the new driver?
> Threading with the Kanalog/Kflop, and using the Mach3 wizards, has been
> excellent since you sorted it out.
>
> Ross
>
